Planet WGSD-10020 Manuel d'utilisateur Page 534
- Page / 557
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
User’s Manual of WGSD-10020 Series
9. TROUBLE SHOOTING
This chapter contains information to help you solve problems. If the Ethernet Switch is not functioning properly, make sure the
Ethernet Switch was set up according to instructions in this manual.
■ The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of the Ethernet Switch
■ Some stations cannot talk to other stations located on the other port
Solution:
Please check the VLAN settings, trunk settings, or port enabled / disabled status.
■ Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full duplex and the partner is set to half
duplex, then the performance will be poor. Please also check the in/out rate of the port.
■ Why the Switch doesn't connect to the network
Solution:
1. Check the LNK/ACT LED on the switch
2. Try another port on the Switch
3. Make sure the cable is installed properly
4. Make sure the cable is the right type
5. Turn off the power. After a while, turn on power again
■ 100Base-TX port link LED is lit, but the traffic is irregular
Solution:
Check that the attached device is not set to dedicate full duplex. Some devices use a physical or software switch to change
duplex modes. Auto-negotiation may not recognize this type of full-duplex setting.
■ Switch does not power up
Solution:
1. AC power cord not inserted or faulty
2. Check that the AC power cord is inserted correctly
3. Replace the power cord If the cord is inserted correctly, check that the AC power source is working by connecting a
different device in place of the switch.
534
- TABLE OF CONETNTS 3
- 1. INTRODUTION 20
- 1.3 How to Use This Manual 22
- 1.4 Product Features 23
- 1.5 Product Specification 26
- - Port Number 27
- 2. INSTALLATION 29
- 2.1.2 LED Indications 30
- 2.1.3 Switch Rear Panel 32
- 2.2 Install the Switch 33
- 2.2.2 Rack Mounting 34
- 3. SWITCH MANAGEMENT 38
- 3.3 Administration Console 39
- Direct Access 40
- 3.4 Web Management 41
- 4. WEB CONFIGURATION 43
- 4.1 Main Web Page 46
- 4.2 System 48
- 4.2.1 System Information 49
- 4.2.2 IP Configuration 50
- 4.2.3 IPv6 Configuration 51
- 4.2.4 Users Configuration 52
- 4.2.5 Privilege Levels 55
- 4.2.6 NTP Configuration 57
- 4.2.7 UPnP 58
- 4.2.8 DHCP Relay 59
- 4.2.9 DHCP Relay Statistics 61
- 4.2.10 CPU Load 63
- 4.2.11 System Log 64
- 4.2.12 Detailed Log 65
- 4.2.13 Remote Syslog 66
- 4.2.14 LED Power Reduction 67
- 4.2.15 EEE Power Reduction 68
- 4.2.16 Thermal Protection 69
- 4.2.17 Web Firmware Upgrade 70
- 4.2.18 TFTP Firmware Upgrade 71
- 4.2.19 Configuration Backup 72
- 4.2.20 Configuration Upload 74
- 4.2.21 Factory Default 75
- 4.2.21 System Reboot 76
- 4.3.1 SNMP Overview 78
- 4.3.4 SNMPv3 Configuration 82
- 4.3.4.2 SNMPv3 Users 83
- 4.3.4.3 SNMPv3 Groups 85
- 4.3.4.4 SNMPv3 Views 86
- 4.3.4.5 SNMPv3 Access 87
- 4.4 Port Management 89
- 4.4.4 Port Statistics Detail 92
- 4.4.5 SFP Information 95
- 1000Base-SX 95
- 1000Base-LX 95
- 100Base-FX 95
- 4.4.6 Port Mirror 96
- Buttons 98
- : Click to save changes 98
- 4.5 Link Aggregation 99
- 4.5.1 Static Aggregation 101
- 4.5.2 LACP Configuration 103
- 4.5.3 LACP System Status 104
- 4.5.4 LACP Port Status 105
- 4.5.5 LACP Port Statistics 106
- 4.6 VLAN 107
- 4.6.2 IEEE 802.1Q VLAN 108
- ■ 802.1Q VLAN Tags 109
- 4.6.3 VLAN Basic Information 111
- 4.6.5 VLAN Membership 116
- 4.6.6 VLAN Membership Status 117
- 4.6.7 VLAN Port Status 119
- 4.6.8 Private VLAN 120
- 4.6.9 Port Isolation 121
- 4.6.10 VLAN setting example: 123
- 4.6.10.3 Port Isolate 128
- 4.6.11 MAC-based VLAN 130
- 4.6.12 MAC-based VLAN Status 131
- 4.6.13 Protocol-based VLAN 132
- 4.7 Spanning Tree Protocol 135
- 4.7.3 Bridge Status 143
- 4.7.5 MSTI Priorities 147
- 4.7.6 MSTI Configuration 147
- Configuration Identification 148
- MSTx MSTI Port Configuration 150
- 4.7.8 Port Status 151
- 4.7.9 Port Statistics 152
- 4.8 Multicast 154
- Type Response Time 156
- 4.8.5 IGMP Snooping Status 161
- 4.8.6 IGMP Group Information 163
- 4.8.7 IGMPv3 Information 163
- 4.8.11 MLD Snooping Status 168
- 4.8.12 MLD Group Information 170
- 4.8.13 MLDv2 Information 170
- 4.8.14 MVR 171
- 4.8.15 MVR Status 173
- 4.9 Quality of Service 175
- 4.9.2 Port Policing 176
- 4.9.3 Port Classification 177
- 4.9.4 Port Scheduler 179
- 4.9.5 Port Shaping 180
- 4.9.6 Port Tag Remarking 182
- 4.9.7 Port DSCP 183
- 4.9.8 DSCP-Based QoS 185
- 4.9.9 DSCP Translation 187
- 4.9.10 DSCP Classification 190
- 4.9.11 QoS Control List 191
- 4.9.12 QoS Status 195
- 4.9.14 QoS Statistics 197
- 4.9.16 Voice VLAN OUI Table 200
- 4.10 Access Control Lists 201
- 4.10.3 ACE Configuration 204
- MAC Parameters 206
- IPv4 frame 209
- ICMP Parameters 210
- TCP/UDP Parameters 211
- Ethernet Type Parameters 212
- 4.11 Authentication 216
- System Configuration 222
- Port Configuration 225
- Port State 233
- Port Counters 234
- Selected Counters 237
- Attached MAC Address 238
- 4.11.7 RADIUS Overview 243
- 4.11.8 RADIUS Details 244
- RADIUS Accounting Servers 248
- 4.12 Security 259
- 4.12.2 Access Management 262
- 4.12.4 HTTPs 264
- 4.12.5 SSH 265
- 4.12.6 Port Security Status 266
- Port Status 267
- 4.12.7 Port Security Detail 268
- 4.12.8 DHCP Snooping 269
- 4.12.12 ARP Inspection 273
- 4.13 Address Table 276
- 4.14 LLDP 282
- 4.14.3 LLDPMED Configuration 285
- Coordinates Location 286
- Civic Address Location 287
- F RFC 2474) 288
- Port Policies Configuration 290
- 4.14.4 LLDP-MED Neighbor 291
- 4.14.5 Neighbor 294
- 4.14.6 Port Statistics 296
- 4.14.7 Port Statistics 297
- 4.15 Network Diagnostics 300
- 4.15.2 IPv6 Ping 301
- 4.15.3 Remote IP Ping Test 302
- 4.15.4 Cable Diagnostics 303
- 4.16.2 Power Configuration 306
- 4.16.3 Port Configuration 309
- 4.16.4 PoE Status 311
- 4.16.5 PoE Schedule 312
- 4.16.6 LLDP PoE Neighbours 314
- 4.16.7 PD Alvie-check 315
- 5. COMMAND LINE INTERFACE 317
- Configure IP address 318
- 5.2 Telnet Login 320
- 6. Command Line Mode 321
- Example: 329
- 6.2 IP Command 330
- 6.7 Security Command 363
- Security Network ACL Delete 411
- 6.9 Link Aggregation Command 444
- 6.11 LLDP Command 451
- LLDP Info 456
- 6.12 LLDPMED Command 457
- LLDPMED ECS 458
- LLDPMED Port Policy 460
- 6.13 EEE Command 463
- 6.15 Thermal Command 469
- 6.16 LED Power Command 471
- QoS QCL Delete 490
- 6.18 Mirror Command 493
- 6.19 Configuration Command 495
- 6.20 Firmware Command 496
- 6.21 UPnP Command 498
- 6.22 MVR Command 500
- 6.23 Voice VLAN Command 504
- 6.24 IPMC Command 511
- IPMC Parameter URI 521
- 7. SWITCH OPERATION 527
- 7.5 Auto-Negotiation 528
- What is PoE? 529
- The PoE Provision Process 531
- Classification 532
- Start-up 532
- Operation 532
- 9. TROUBLE SHOOTING 534
- APPENDEX A 536
- 12345678 537
- APPENDEX B : GLOSSARY 538
- EC Declaration of Conformity 556
Produits connexes et manuels pour Routeurs Planet WGSD-10020
Routeurs Planet WGSD-10020 Manuel d'utilisateur
(373 pages)
(373 pages)
Routeurs Planet WGSD-1022 Manuel d'utilisateur
(355 pages)
(355 pages)
Routeurs Planet WGSW-2620HP Manuel d'utilisateur
(211 pages)
(211 pages)
Routeurs Planet WGSW-50040 Manuel d'utilisateur
(437 pages)
(437 pages)
Routeurs Planet WGSW-5242 Manuel d'utilisateur
(286 pages)
(286 pages)
Routeurs Planet WGSW-52040 Manuel d'utilisateur
(505 pages)
(505 pages)
Routeurs Planet WGSW-52040 Manuel d'utilisateur
(876 pages)
(876 pages)
Routeurs Planet XGS3-24040 Manuel d'utilisateur
(582 pages)
(582 pages)
Routeurs Planet XGS3-24040 Manuel d'utilisateur
(869 pages)
(869 pages)
Routeurs Planet XGS3-24042 Manuel d'utilisateur
(721 pages)
(721 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.159 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels